Proper height for a garage door sensor is 4 to 6 inches 10 2 to 15 2 cm.
Garage door safety sensor height.
If the sensors are installed above 6 inches above the floor they may not detect an individual.
Slide the bracket along the track so that it is approximately 6 inches above the ground.
That s because they might not trigger properly otherwise and people or animals could get trapped under the door as it closes.
Consumer product safety commission.
Safety standards regulate this height at 6 inches from the floor surface.
Lying down on the garage floor under the closing door.
Ul in the entrapment protection provisions.
The sensors use two photo.
The sensors should be symmetrical in this height for the light beams to work properly.
If your garage door sensors are outside of this range remove them entirely from the garage door frame and install leveled inside the safe zone.
The current mounting height of these sensors could allow a small child to lay beneath them and still not break the beam.
Safety sensors include two mounted sections one on each side of the garage door opening.
This is so that any small children or pets will not be hurt if they are in the way of the door.
Auto reverse sensors mounting height.
The sensor should be facing the.
Chamberlain liftmaster craftsman garage door opener replacement safety sensors g801cb p includes 2 sensors mounting brackets and hardware.
4 6 out of 5 stars 32.
Install the brackets provided at the same height of the beams you have just removed.
Higher than that can miss many low lying objects including pets.
Current standards require that safety eye sensors be mounted not more than 6 inches above the floor.
The object under the door needs to break the sensor s infrared beam in order for the sensor to work.
Periodic checks and adjustments.
Press the bracket s clip onto the garage door s track near the ground.
The two positioning factors are sensor alignment and sensor placement height.
Garage door opener safety sensors universal photo cells safety beams.
The height of these auto reverse sensors on the garage doors was roughly 1 5 feet off the ground.
Lower is easy to stand above with a foot on either side.
4 7 out of 5 stars 1 676.
The sensors should detect anything under the.
I thought 4 6 inches up is the recommended height.
The consumer product safety commission commission or cpsc is issuing a final rule amending the regulations for the safety standard for automatic residential garage door operators to reflect changes made by underwriters laboratories inc.
As a general rule garage door sensors should be mounted not more than six inches above the floor.
