Ge Front Load Washer Starts Shut Down With Door Locked

Save up to 2000 on select ge profile appliance packages.

Ge front load washer starts shut down with door locked.

The door lock secures the washer door shut during operation. If the door lock is defective the washer may stop mid cycle. It should be an oblong hole that is aligned so that a rod on the inside of the door will fit into it. I show the symptoms.

Turned machine off and unplugged it but the door will not unlock. Plug the washing machine back in and then within 30 seconds quickly open and close the lid six times. My top load. The door should unlock.

The lid switch is the part on top loading washing machines that sends the machine a signal indicating that the door is closed and that it is safe for the machine to run. Plugged the maching back. Our frequently asked questions page gives answers to common questions about ge washers. However if the door stays locked but the switch is bad then the control will think the door is open and the washer will pause.

If the door will not latch then the washer will not start. With the lower access panel removed and the washer unplugged reach up to the door lock and feel for a round release ring and pull it down. You ll need to do this within a 12 second period. If the washer door is not latched shut the door switch prevents the washer.

Find the lid switch. Once the washer door is closed the washer can begin operating. To reset washing machines that use the ge hydrowave system start by unplugging the washer for one minute. Our front loader door won t open and won t go into service mode.

Enter and space open menus and escape closes them as well. To manually unlock the door on this washer you first unplug the washer from the wall outlet and then remove the lower access panel. The door latch can cause a ge frontload washer to pause during a cycle. Raise the lid at least 2 inches and make sure it closes each time.

Replacing the door lock fixed it. Up and down arrows will open main level menus and toggle through sub tier links. My ge front load washing machine has stopped water is leaking from the door and the door locked light is on. You can unlock the unit by removing the three screws at the bottom front of the unit.

Pull down on it and the door will open. See the image below for how to do this. Reach up inside of the unit near where the door lock is and you will feel a small tab at the bottom of the lock assembly. Best priced door lock for this ge.