Check garage door for binding.
Genie garage door keeps opening and closing.
How to fix a garage door that keeps reversing.
This is actually a very rare problem of all the garage door installation problems you can have but when it happens it s usually a short in the circuit board says andrew richards owner of legacy.
This is done with the help of sensors in the motor and on each side of the opening near the floor and mounted on the tracks.
Door starts down then stops before it is closed.
Open the garage door and watch it closely as it opens.
When the garage door opens about halfway or 5 feet from the ground and stops the up limit switch needs to be adjusted.
Check for interference from adjacent photo eye sensors of any brand.
When the logic board wears out it can cause your garage door to close then open and vice versa without explanation.
It goes partway down reverses direction and goes back up again.
You have an open limit and a close limit on your garage door opener.
In the down direction if the limit is set beyond the point at which the door closes fully the door will hit the floor and act as if it is hitting something and the safety feature tells it to reverse.
In some rare cases a garage door will open or close by itself even if the homeowner hasn t instructed the automatic garage door opener to do so.
Press and hold the wall console button until the garage door is completey closed.
The likely culprit is an obstruction in the path of the garage door.
Your garage door s logic board is the brain of your garage door opener.
Get logic board replacement.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
Check for and clear any obstructions in its way.
You push the button to close the garage door.
These limits set the distance the door will open or close before stopping.
This brain can wear out in time so you could need a replacement.
If it is be sure that the lenses are mounted five to six inches from the floor on either side of the garage door opening.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
