Past several weeks the remotes are not working and the door seems to just do.
Genie garage door starts to close then goes back up.
If it is a new installation check the postion of the door arm.
Close the garage door with the opener and watch it closely as it closes.
Just recently when the door closes it reaches the floor and then goes all the way back up again.
This means it is in the engaged position.
Your garage door s logic board is the brain of your garage door opener.
Check if the limits are properly set.
My garage door starts to close and then opens back up as if it is hitting something.
You push the button to close the garage door.
Notice in the first image below the slotted gap in the bar that the red cord is attached to disappears.
Adjust the limits as needed.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
This brain can wear out in time so you could need a replacement.
Disconnect the garage door opener from the door and go through the troubleshooting.
Then sometimes it reverses at the bottom sometimes it reverses right after it starts moving.
My garage door opener doesn t close all the time.
Installed a genie garage door opener several months ago.
If there solid and the door still doesnt go down hold the button on the inside of the garage that is on the wall all the down until the garage door goes down and let me know if it goes down now.
It goes partway down reverses direction and goes back up again.
Get logic board replacement.
Garage door opener stops or reverses when activated.
Please click accept if you have been helped.
When the logic board wears out it can cause your garage door to close then open and vice versa without explanation.
Check your sensors on each side of the garage door and make sure that boith lights are solid.
You should now be able to operate the door using your genie garage door opener.
Make sure only the safe t beams that came with this garage door opener are installed.
Then manually lift or close the door until the carriage locks into place.
Back to garage door question list.
Check if the safe t beams red led light.
Garage door starts down then stops and goes back up or safe t beam system malfunction.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
